Ikonex for Windows

Tahoma Technology
(formerly Ikon Corporation)
2819 Elliott Ave
Suite 203
Seattle, WA, USA, 21

206.728.6465
http://www.tahomatech.com
tahoma@tahomatech.com

8 March, 2007		added big- and little-endian ioctls

20 April, 2004		added interactive mode

13 March, 2012		modified for Windows

NOTE: This version of ikonex is heavily modified for the Windows
environment.  It runs with the Moxie ikonpci driver - as modified
by OYO - which must be installed on the host machine.

Ikonex is a command line based utility program that can be used
to test and exercise a Tahoma Technology (formerly Ikon
Corporation) Hardcopy interface board and the attached
printer/plotter.  It is based on the Ikondma program written by
Bill Simpson at Interface Consultants.

This version of ikonex can be run from the command line with all
parameters specified in the command line, or in interactive mode
by starting as:  ./ikonex -i

Ikonex is self-documenting.  ./ikonex or ./ikonex -h for usage 
information.

Ikonex can output pre-formatted print and/or plot files (if
available), manipulate plotter modes, send pulsed commands, set
interface parameters such as handshake speed, and retrieve
interface and plotter status.  Data bytes may also be sent
directly from the keyboard.

The compressed zip file provided here includes the ikonex.c source
file, the Moxie/OYO ikonctl.h header, and a pre-compiled executable.

The executable was built with Visual Studio C++ 2008 Express
Edition.  It has been (BETA) tested on systems running Windows XP
Pro, Windows 7 32-bit, and Windows 7 64-bit.